7.4V Lipo Battery Charger for DFRbot Yellow 7.4V Lipo Battery AC100-240V 50/60Hz

7.4V Lipo Battery Charger for DFRbot Yellow 7.4V Lipo Battery AC100-240V 50/60Hz

Introduction
- A Difficult Choice Made Easy
- The choice of LiPo batteries and battery chargers can be overwhelming. In the past, with older RC cars and NiCd batteries, you could just take the battery, plug it into a wall charger, and leave it. After several hours, or preferably overnight, your battery would be ready for use again. LiPo batteries are a completely different animal.
- If you don’t select a higher-end charging station, they will require a lot of your time and attention. And if you don’t treat them right, they can be downright dangerous.
- But with this 7.4V Lipo Battery Charger, things become just as easy as before. This charge is able to take in AC100-240V 50/60Hz power and output at DC 8.5V 1.5A. It comes with standard DC 2.1mm (Female/Male) interface which is Arduino compatible, and has short-circuit protection, reverse-connection protection, over-charge protection and backflow protection protection. A perfect companion to the 7.4V Lipo Battery (2-cell pack).

Specification:
- Input: AC100-240V 50/60Hz
- Output: DC 8.5V 1.5A
- Interface: DC 2.1mm (Female/Male) (Arduino compatible)
- Led Indicator: Red (charging), Green (charged), Green Flash (protection mode triggered)
- Support Battery: 7.4V Lipo Battery (2-cell pack)
- Protection: converse connection, over-charge and discharge over-loading, short-circuit protection.
- Certification: CE,UL,FCC,GS
- Size: 70 mm × 75 mm × 40 mm
- Weight:  90g

Package list:
- 7.4V Lipo Battery charger x1
- DC 2.1mm female to female connector x1