Assembled RC Tank Chassis Tracked Chassis DIY Climbing Car 3D Printing Load 5KG With Motors 370

Assembled RC Tank Chassis Tracked Chassis DIY Climbing Car 3D Printing Load 5KG With Motors 370

Features:
- Voltage: Within 9V
- Load capacity: 5KG (3-3.5KG recommended)
- Two motors respectively control one side
- Thick gears are strong and durable
- The whole car has nearly 28 bearings

Motor Parameters:
* 6V: 17000 rpm, no-load current: 300ma
* 7.4V: 20700 rpm, no-load current: 380ma
* 11.1V: 32400 rpm, no-load current: 510ma
* 11.1V no-load power: 5.7W
* Shaft length: 10.5MM
* Shaft diameter: 2MM
* Carbon brush

Attention:
- The crawler chassis is made of 3D printing technology (fdm type printer), so the surface is not beautiful, rough textures, cracks, etc. cannot be avoided, but it does not affect the use. Please make sure that you don't mind before purchasing.
- The large current of this 370 motor has certain requirements for remote control to prevent main board from burning. And the wire used should be thick enough.
- For this car, please use 2s or more batteries (various batteries within 9v)
- The power of this 370 motor is very large, and the locked-rotor current may exceed 10A, so when using 2S lithium batteries, please use a receiving version of at least 5A.
- This type of motor is easy to overheat, it is best to do a cooling treatment.
- It is best for your remote control to be able to adjust the speed, otherwise it will be the maximum speed as soon as it is started, which will cause too much impact on the gear and increase the wear.

Package Included:
- 1 x Tank Chassis

Note:
- It is assembled.
- It comes with motors but without battery or remote controller. It is a DIY product.