| Quantity | 3+ units | 10+ units | 30+ units | 50+ units | More |
|---|---|---|---|---|---|
| Price /Unit | $7.37 | $7.22 | $6.99 | $6.69 | Contact US |
Fourth Generation 2200mAH Handheld Tesla Coil Punk Tech Style Decoration 10CM Artificial Arc Support Voltage Display
$74.49
Fourth Generation 2900mAH Handheld Tesla Coil Punk Tech Style Decoration 10CM Artificial Arc Support Voltage Display
$80.32
ExpressCard to M.2 Wireless Network Card Adapter Compatible with ExpressCard34 and ExpressCard54 Interface
$18.87
Axis Breakout Board 5-axis Stepper Motor Driver Interface Controller CNC Mill MACH3
Description
The latest upgraded 5 axis breakout board is specially designed for the CNC single axis 2-phase stepper driver controller. The breakout board using high-performance three-state bus driver 74HC244 and Schmitt inverter 74HC14 amplified. The input signal is amplified, rectified, filtered to make the drive capability of the output signal more stable and stronger. With this 5 axis breakout board, any 1-5 Micro stepper driver controllers can be directly controlled by the PC via the MACH3, EMC2, KCAM4, etc. parallel-control CNC software.
Features:
- High performance, cost-effective.
- Maximum support 5-axis stepper motor driver controllers.
- Compatible with MACH3, Linux CNC (EMC2) etc. parallel-control CNC software.
- USB power supply and peripherals powered phase are separated to protect computer security.
- All the signals are opto-isolated which can protect your computer security.
- 5-input interface to define the Limit, Emergence-Stop, Cutter alignment etc.
- Wide input voltage range: 12-24V, and with anti-reverse function.
- One relay output control interface, accessed by the spindle motor or the air pump, water pump, etc.
- Compatible with all the 2 phase micro step drivers in the market.
- Output 0-10V analog voltage for inverter to control the spindle speed.
Specifications:
Input Voltage: USB port from PC or 12-24V power supply(optional)
Drive type: Pulse and Direction Signal Control
Suitable Microstep Driver: 2 Phase Microstep Driver
Net weight:Approx 122g
Dimensions:89.7 * 68.5 * 19.5mm (L*W*H)
NOTE:
Solemnly declares on the engraving machine size: the laptop must bring its own parallel port, and the USB transfer port can not be used! ! MACH3 software supports WIN XP system (recommended!), WIN7 32-bit barely can be used, WIN7 64-bit system does not support!
The USB parallel port line cannot be used because the parallel port that is turned out to be virtual.
Package included:
1 x 5 Axis Breakout Board
1 x USB Power Cable
