| Quantity | 3+ units | 10+ units | 30+ units | 50+ units | More |
|---|---|---|---|---|---|
| Price /Unit | $145.00 | $142.04 | $137.60 | $131.68 | Contact US |
Waveshare USB to RS232/485/TTL Interface Converter Communication Module (CH343G Chip) w/ Isolation
$29.31
Waveshare USB to RS232/485/TTL Interface Converter Communication Module (FT232RNL) w/ Isolation
$33.20
Mini Duplex Hotspot Motherboard for MMDVM Digital Modem Box and 433MHz Antenna Support for DMR / D-Star / NXDN / POCSAG
$32.08
CJMCU-3DOF Inertia Measurement Combo Develop Board 3 DOF ADXL203+ADXRS614 Gesture
Description:
- None. There is no direct replacement for this part, but we have plenty of alternatives in our IMU category. This page is for reference only.
- The Inertia Measurement Unit Combo Board with the high-precision ADXL203. The ADXL203 sensor is a much higher precision sensor with a range of +/-1.5g. This small PCB board incorporates the Analog MEMs gyroscope and accelerometer in a tight footprint. The IMU board uses a standard .1" header and includes all outputs from both the ADXRS Gyro and ADXL Accelerometer ICs.
- We created this board because of the retirement of the Tokin CG-16D piezoelectric sensors. These cheap sensors are now becoming obsolete and difficult to find. The ADXRS sensors from Analog are a great substitute but hobbyists were hindered by the BGA package. By combining the ADXRS with the ADXL sensors, the IMU board enables students and hobbyists to easily incorporate yaw and tilt measurements into their projects or robots.
- Board comes fully assembled and tested with ADXL203 and ADXRS614. Units come as shown without headers installed. We recommend right-angle break away headers, straight pin headers, or wire up your own cable!
