Dog Trainer 1 to 2 Dogs Rechargeable LCD 100LV Level Shock Vibra Pet Dog Remote Training Collar 300 Yards

Dog Trainer 1 to 2 Dogs Rechargeable LCD 100LV Level Shock Vibra Pet Dog Remote Training Collar 300 Yards

Features:
- The Remote Transmitter & the Collar Receiver can be Rechargeable and waterproof.
- 100 levels of vibration & static(levels can be altered by use of up & down button.)
- LCD Display
- The Collar length can be adjustable from 12" to 21"
- Remote range up to 300 Yards
- Effective on 10 to 130 pounds of dogs
- The system can be used  for 1 or 2 receivers.

NOTE:
- If you hear noise from the collar when you shock it, it is normal as it comes from the charging beads inside.
- Presently, this product is the most effective and safest tool for training pet. Following the operational instructions, you can effectively train the pet and bring it no harm.

Charge the Remote Transmitter:
- Connect the charger connector to the charging jack.
- Plug the charger into a standard outlet.
- The red light on the Transmitter will be lighted.
- Charge the Transmitter at least 6 hours for the first charger.
- After fully charged, the red led will be turned off automatically.
- Low battery Indicator(the symbol) :Q will show up on the right down side of LCD screen.

How to Use the Transmitter:
- To turn on/off the Transmitter, hold the Transmitter for 5 seconds.
- Set to the different modes by pressing the Mode button----the LCD images will change.
- Press the up and down buttons on right hand side to set level.
- Choose the different channels for 1 or 2 receivers.
- The Transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if not operated for 2 minutes.
- In STANDBY MODE, press any button (except LED light button) to wake it up.

Charge the Collar Receiver:
- Connect the charger connector to the charging jack.
- Plug the charger into a standard outlet.
- The red LED light inside the Collar Receiver will be lighted.
- Charge the Collar Receiver at least 6 hours for the first charge.
- After fully charged, the red LED light will be turned off automatically.
- When charging is completed, put the rubber cover in the right position to keep the internal unit from dust and water.
- Low battery Indicator: the Collar Receiver will keep beeping for 2 minuets unless It gets charged.

Connect the Transmitter with the Collar Receiver:
- Turn on the Transmitter and choose 1 or 2 channels to encode.
- Lift the Reset part of the Rubber cover in the Collar Receiver.
- Use a toothpick or paper click to insert into the Reset HOLE inside the Collar Receiver.
- Press the LAUNCH button on the Transmitter immediately while you are hearing a beep from the collar.
- The Collar Receiver will beep , it means that the Transmitter has encoded the collar.
- After completion, put the rubber cover in the right position to keep the internal unit from dust and water.

Package Include:
- 1 x Remote control unit
- 1 x Collar
- 1 x Charger & cord
- 1 x Test light &replacement probes
- 1 x Operating Instructions