| Quantity | 3+ units | 10+ units | 30+ units | 50+ units | More |
|---|---|---|---|---|---|
| Price /Unit | $30.15 | $29.54 | $28.62 | $27.39 | Contact US |
USBCAN Debugger USB to CAN Bus Analyzer Compatible with PCAN Support Offline Playback for CANTest/CANMonitor/TSMaster
$37.60
Dual Channel CANFD USB to CANFD CAN Debugger Support for CANTest/PCANView/TSMaster Compatible with ZLG PCAN FD
$105.99
Dual Channel CANFD & Dual Channel LIN USB to CANFD CAN Debugger 25Kbps-5Mbps Compatible with ZLG PCAN FD
$121.54
DSTIKE Bootloader Flash Tool (2x3P) For Arduino ISP Arduino Bootloader Development Programmer
What is it?
It is a bootloader flash tool for Arduino products. If you do not understand what is bootloader, I suggest you have a look this:
* Bootloader Development
* For Arduino as ISP and Bootloaders for Arduino
Why did you make it?
Now I have some products for Arduino like Wifi Duck. Bootloader is a problem during develop process for Arduino. I want to share my experience for those Arduino developers. Now I only use it for Arduino Leonardo as my target but theoretically other target is also OK.
What makes it special?
It is pre-flashed with ISP software for Arduino
* Connect Flash Tool and computer via a Micro-USB cable.
* Connect Flash Tool to the target board.
* Indicate LED will turn off for about 10 seconds.
* Wait until LED turn up.
* Open IDE for Arduino and select the item in the Tools->Board menu that corresponds to the board on which you want to burn the bootloader (For Arduino Uno, Nano, Leonardo...).
* Select Port COMXX (For Arduino, Leonardo).
* Selection for Arduino as ISP (Atmega32u4) in the Tools>Programmer menu.
* Use the Burn Bootloader command.
* You will see Indicate LED is twinkling when burning process start.
* Twinkling LED will be off and software says Finish at the same time when burning process finish.
Package Included:
- 1 x Set of Bootloader Flash Tool
