ESC5500E Genset Controller Electronic Speed Governor Generator Controller Speed Control Board System

ESC5500E Genset Controller Electronic Speed Governor Generator Controller Speed Control Board System

Description:
Built on the basis of PER5500E, ESC5500E is designed with newly added overspeed protection function, which greatly improves the safety and reliability of engine. It is currently the most functional and complete model, and is widely used in new generators. (PER5570E is a governor specially designed for supporting Cumming EFC actuators. And its function is the same as PER5550E.)

Technical Specifications:
- Speed stability: better than ±0.25%
- Speed range: 1KHz~7.5KHz
- Thermal stability: maximum ±1%
- IDLE regulation: 160 ±20Hz ~95% of rated speed
- DROOP adjustment: The minimum position is 15Hz ± 6Hz /load current change per ampere; Maximum position 400Hz ±75Hz/load current change per ampere
- External speed adjustment: ±200Hz (external connection 1KΩ)
- AUX input sensitivity: 148Hz/1V, ±10Hz
- Impedance: 1MΩ
- START FUEL adjustment: 160 ±20Hz ~70% of rated speed
- RAMP time adjustment: 1.5~20 Sec.
- Overspeed protection adjustment range: 1500Hz~7.5kHz
- Overspeed protection action delay: 1.5 Sec.
- 10V output current: 20mA max.

Surroundings:
- Operating temperature range: -40℃ to 85℃/-104℉ to 185℉
- Operating humidity range: up to 95%
- Storage temperature: -55℃ to 90℃/-131℉ to 194℉
- Vibration: 20-100HZ 500mm/Sec.

Input Power Supply:
- Power supply voltage: 12V and 24V DC battery system
- Ground polarity: negative
- Power consumption: 50mA
- Actuator continuous current: 2.5A minimum; 10A maximum
- Speed sensor signal: 0.5~120 RMS

Installation:
Installation size: 127 x 152mm/5 x 6"

Attention:
The above performance parameters are measured at a working frequency of 4000Hz.

Package Included:
- 1 x Generator Controller

Note:
- Battery is not included in the package.