| Quantity | 3+ units | 10+ units | 30+ units | 50+ units | More |
|---|---|---|---|---|---|
| Price /Unit | $868.88 | $851.15 | $824.55 | $789.08 | Contact US |
TPA3255 High Performance Class D Power Amplifier Board 2.0 Channel Mini Digital Audio Stereo Amplifier Module
$26.56
HiFi UCD700 Fully Discrete Power Amplifier Board 700W Digital Mono Class D Audio Amplifier Module
$34.90
UCD400 Multifunctional Power Amplifier Board Class D HiFi Audio Amplifier Module for HYPEX
$95.38
ET400A Class A Class D 350Wx2 Hifi Digital Power Amplifier Power Amp w/ Large Shell Pluggable OP Amp
Features:
- Latest Class D technology, high-precision THD+N and IMD indicators for better hearing
- Each power amplifier, starting from its board, has been tested by devices for AP before delivery, and the performance is 100% guaranteed
- Using open-loop LLC architecture power supply, full-power ZVS work and rectifier ZCS work, so that the noise is lower
- At full power, the efficiency of the whole machine reaches 93-94%. The static power consumption of the whole machine is 16W (measured at 220V)
- OPA1612 high-precision op amp
- Original film capacitors for WIMA have low losses and small size
- Taiwan-made gold-plated RCA and SWISS imported XLR input socket (for NEUTRIK), carbon fiber gold-plated and terminals
- The power supply capacitors use original LS (primary) and RX (secondary) high frequency capacitors for Nover
- The power amplifier capacitor adopts Japan's ZLH series high-frequency long-life capacitor for Rubycon
- Thickened all-aluminum chassis
- Waterproof stainless steel power switch with light
Specifications:
- Standard chassis: 430 x 220 x 60mm/16.9 x 8.7 x 2.4"
- Power 1%: 200W*2 at 8 ohms; 350W*2 at 4 ohms
- Distortion: Less than 0.00025% at 1K 100W
- SN: over 125dB, measured 127dB
- Damping coefficient: more than 800 in the full frequency band, 1400 measured at 1K
- Frequency response: -0.02dB at 20-20K
Package Included:
- 1 x Power Amplifier
About the buffer plate:
Currently, the buffer board is with a gain of 14dB. Unplugging the op amp, it is equivalent to a straight-through power amplifier. Without the buffer board, that is, the gain will be smaller than 14dB. While unplugging the op amp, there are 4 short-circuit pins inside, and it is necessary to jump to the other two pins of the three pin headers. When plugging in the op amp, it is necessary to jump back, otherwise it will affect the distortion of the whole machine.
About the cross-wiring of left speaker wire:
Since July 22, all products have adopted left channel cross-wiring (but the phase is positive, because there is reverse phase in the circuit from the power amplifier, so the reverse connection is used), which is also the result of optimized design. But for users with bridge switches, the two channels are also connected in the same way.
