| Quantity | 3+ units | 10+ units | 30+ units | 50+ units | More |
|---|---|---|---|---|---|
| Price /Unit | $138.25 | $135.43 | $131.20 | $125.55 | Contact US |
RideNow R1 100PSI Mini Electric Air Pump Electric Bicycle Pump Bike Pump for 7.4V Fast Inflation
$60.02
RideNow R1 S 120PSI Mini Electric Air Pump Bike Pump with Air Pressure Display + 7.4V for Inflation
$81.78
RideNow R1 MAX 150PSI Mini Electric Air Pump with Preset Tire Pressure + Display + 11V Inflation
$83.72
HB-113 Brushless Wheel Hub Motor 150KG Load 24V/36V High Power Scooter Motor Scooter Accessories
Features:
- Built-in reduction gear
- Low speed and high torque
- Maximum load 150KG
- Thickened rubber wheel wear-resistant
Specifications:
- Motor model: HB-113
- Rated voltage: 24V/36V
- Rated power: 200W/290W
- No-load current: less than 1A
- Rated current: 9A
- Rated torque: 6.5N.m
- No-load speed: 24V 290 rpm; 36V 420 rpm
- Number of pole pairs: 10
- Motor weight: 2255g
- The motor comes with Hall sensor
- Waterproof rating: IP44
- No-load noise: 55d
- This motor has a built-in reducer, and the reduction ratio is 1:4 (the speeds listed on the Internet are all speeds after deceleration)
- Application fields: electric scooters, robots, intelligent hardware equipment, mechanical intelligent mobile modification fields, etc.
Package Included:
- 1 x Wheel Hub Motor
Motor Hall Introduction:
- Motor Phase Cable: U-thick blue wire; V-thick yellow wire; W-thick green wire
- Hall Cable: 5V-red wire; negative-black wire; U-blue wire; V-yellow wire; W-green wire
Attention:
The above is the reference data for the test on the conventional road surface with slope less than 5 degrees with motor wheels installed
Precautions For Motor Selection:
A. The motor load weight listed in the above figure refers to the use of 1, 2, and 4 motors as the driving wheels of the carrier. When the carrier starts at a standstill, the speed control accelerator (push rod or knob) is added to maximum, the maximum weight that can be driven on the carrier.
B. The following two ways of using will make the motor power smaller:
1. When the motor is running at a reduced speed, the lower the speed, the smaller the force. This motor is not suitable for operating scenarios below 1 km/h.
2. When the motor is used in a larger wheel, due to the principle of leverage, the larger the diameter of the outer wheel, the smaller the motor force.
C.For modification purposes in other fields, due to different performance requirements such as force method, resistance, torque, etc., please communicate with customer service before placing an order.
