IHSV57-30-18-36-01-T-33 57 Integrated Servo Motor 180W 0.6NM 3000RPM AC Servo Motor And Driver

IHSV57-30-18-36-01-T-33 57 Integrated Servo Motor 180W 0.6NM 3000RPM AC Servo Motor And Driver

Features:
- 2 In 1: motor and driver in one. Save machine manufacturing cost, reduce wiring complexity and assembly time, save a lot of motor installation space, and effectively reduce heat dissipation in  a chassis
- Feedback makes motion control more accurate: 1000-line high-resolution incremental photoelectric encoder enables the driver to receive the feedback signal of the motor, improving operation control accuracy of the motor, making the positioning accuracy as high as 0.09MM. Accurate positioning and high efficiency enabled
- Quick response, low-speed and smooth operation. The dynamic response time of motor acceleration and deceleration is shorter, and command transmission can generally be completed within ten milliseconds. Motor maintains smooth, quiet operation even in low-speed applications
- Constant torque output and high speed operation: AC servo motor constant torque output, with rated speed up to 3000RPM, meeting the torque and speed requirements of most equipment
- DSP control chip realizes high-speed operation. The 32-bit DSP control chip sends special DSP instructions, which can achieve fast DSP operations. Applying vector control and smooth filtering techniques to achieve smooth motion control of the motor
- Seven kinds of protection make the motor more durable. Adopt over-current protection, 12T, over-voltage, under-voltage, overheating, over-speed and over-tolerance protection. When the motor fails, it will issue an alarm prompt in time to ensure the safety of the motor and your equipment
- Suitable for inkjet printers, printers, industrial robots, AGV cars, automatic assembly and other equipment

Specifications:
- Motor Model: iHSV57-30-18-36-01-T-33
- Power: 180W
- Torque: 0.6NM
- Shaft size: 8 x 33mm/0.3 x 1.3"
- Body length: 148mm/5.8"
- Rated speed: 3000RPM
- Driving voltage: 36VDC

Package Included:
- 1 x Integrated Servo Motor

Fault Analysis:
A. No display after power-on
It may be due to input power failure. Please check the power line and voltage

B. Alarm after power-on or running a small angle
1. Check the connection of the motor feedback signal line and the motor power phase line
2. Check the voltage of the input power supply of the stepper servo drive
3. Please ensure that the phase sequence of the motor is connected correctly. If it is not correct, please refer to the motor identification and the corresponding phase sequence connection of the driver
4. In the drive configuration parameters, whether the number of lines of the motor encoder is consistent with the actual parameters of the connected motor. If the parameters are different, please reset
5. Whether the pulse input speed is greater than the rated speed of the motor so that the position is out of tolerance

C. Motor does not rotate after pulse input
1. Is the wiring of the pulse input terminal of the stepping servo driver reliable?
2. Whether the input mode in the system configuration of the stepper servo drive is related to pulse input
3. Is the motor in the enabled state?