LOTUSRC T700G FPV Foldable Hexacopter ARF Retractable Landing Skid RC Flyer + Flight Controller w/ Motors & ESC Prop

LOTUSRC T700G FPV Foldable Hexacopter ARF Retractable Landing Skid RC Flyer + Flight Controller w/ Motors & ESC Prop

Product Description
- The T700G uses six (6) Brushless motor, direct drive propellers to reach a self-stabilizing position hold. It can also reach vertical position hold as well as move left and right, forward and backward and so on.

The skid landing of this version is electric.

Functions and Features:
The T700G (with GPS) is a high-end aircraft based on the T700 platform. It is meant to be used for professional aerial photo and video collection.
1. Safe: Fully independently flight control. Included features are a low voltage alarm and a lost signal auto return to home function.
2. Efficient: 12inch Slow Fly propellers plus brushless motors give us maximum efficiency at 12.2g/W.
3. Stable: Using high performance, industrial grade MEMS sensors and 6 DOF motion control, our aircraft has a low drift factor. The materials used to build this aircraft are of the highest quality and impact resistant.
4. Simple: Pre-configured with radio control transmitter, no setup required
5. Easy to use: The components are easily assembled and offer intuitive operating commands. Our aircraft are also able to operate in temperatures ranging from 14 degrees Fahrenheit to 140 degrees Fahrenheit.

Standard Features:(The Transmitter, Receiver, Battery, Charger are required for assembly)
- Manual take off, Position take off
- Air fixed-point, auto return home, and auto landing
- Rotating to calibrate the compass (rotate 7-8 laps in the same direction)
- Support biaxial camera mount
- Support all PWM signal ESC
- Support all camera mounts except DJI
- Support the battery within 4S Li-Po
- Provide GPS control wire (It can auto set the Manual Mode, Fixed-Point Mode, and Auto Return Home by connecting corresponding three-stage swith ports on the receiver)
- Low voltage alarm is not supported
- Control distance according to the transmitter

Upgrade configuration I.
Additional equipment
　　　One pair of dedicated Data Transmission (Emitter should be installed to the aircraft, there is a data transmission port in the standard aircraft, and the Receiver installed to the computer USB Port)
　　　A set of ground station software, it need corresponding to the serial number on the aircraft (standard bar-code on the aircraft)
　　　A windows operating system computer (recommended: laptop)

Function:
　　　Track Flight Features: It can fly to anyplace you set point on the map (flying radius is 1km)
　　　Ground station monitors the flight data, including height, distance, voltage, etc.

Upgrade configuration II.
Additional equipment
　　　One pair of dedicated Data Transmission (Emitter should be installed to the aircraft, there is a data transmission port in the standard aircraft, and the Receiver installed to the computer USB Port)
　　　A set of ground station software, it need corresponding to the serial number on the aircraft (standard bar-code on the aircraft)
　　　A windows operating system computer (recommended: laptop)
　　　Connect the computer with the Flight-Ctrl Board through the data cable to upgrade the Flight-Ctrl Board.

Function:
　　　Airline Flight (Standard 4 points)
　　　Flying around the point functions: Subject to the aircraft position, set another point on the map. The aircraft will do circle flight, taking this point as the center and the distance between the two points as radius.
　　　Ground station monitors the flight data, including height, distance, voltage, etc.

Software system
1. GPS software based on Android/iOS, provides a powerful and very flexible ground control support system.
2. All T700G with full functional test and configured for optimum performance.
3. Ongoing systemmaintenance and upgrade service support program.
 

LOTUSRC T700G Technical Parameters

Package Inlcudes:
- 1 x LotusRC T700G RC UFO kit
- 6 x Motor
- 3 pairx Propeller
- 6 x  ESC
- 1 x Flight Controller
- 1 x GPS

The default price is NOT including Transmitter, Receiver, Battery(Support 4S battery) and Charger.