Pair of 2.4G 1W Telemetry Frequency Hopping FPV VTX with GH1.25/USB Double Interface 20KM Long Range for UAV

Pair of 2.4G 1W Telemetry Frequency Hopping FPV VTX with GH1.25/USB Double Interface 20KM Long Range for UAV

Specification:
- Model: LR24-P
- Size: 20 x 40 x 9mm
- Single product weight: 6g
- Antenna: SMA female connector
- Interface: GH1.25-4P / USB Type-C
- Main control: STM32F401
- USB: CP2102
- Working frequency: 2400 - 2482MHz
- Maximum transmitting power: 30dBm (1000mW)
- Communication modulation: LoRa/FLRC
- Communication type: point to point duplex; point to multiple point simplex (broadcast)
- Frequency hopping method: Self interference avoidance random encryption frequency hopping
- Transparent transmission speed: 2.4/4/8/20KByte/s
- Maximum single-packet length: 20KByte
- Reference communication distance: 15 - 30KM (measured in spare space; typical: 20km)
- Working mode: serial port transparent transmission
- Interface level: 3.3V TTL
- Baud rate: 57600 (by default); adjustable
- Working voltage: 4.5 - 5.5V
- Power consumption maximum mean value: 3W
- Maximum transient current: 1A at 5V
- Working temperature: -40℃ ~ 85℃

LR24-P Flight Control Terminal Configuration Instruction:
- Confirm that the data transmission module is in sky mode (with the blue light constantly off).
- Confirm that the data transmission has been correctly connected to the flight control data transmission serial port, using the "TELEM1" interface as an example.
- The flight control is connected to the computer ground station software through USB, such as MP or QGC, and the flight control parameters are configured or checked according to the following instructions.

LR24-P VTX Using Instruction:
- The factory default configuration for LR24-P data transmission is duplex, low-speed mode (2.4KB/s) with a baud rate of 57600.
- Data pairing: As long as the parameters of two arbitrary data transmission modules are consistent, and one side is the ground terminal and the other side is the air terminal, they can automatically pair and communicate after being powered on. A green light on the VTX module indicates that it has been successfully connected.

Parameter configuration:
- You can use the Micoair Assistant software (supporting for WIN10/11) to modify the parameters of the configuration VTX module.
- Connect the VTX module to the PC through a USB interface (TYPE-C).
- Install the CP2102 USB to serial driver. (If an exclamation mark is displayed in the device manager, it indicates that the driver is not installed.)
- Open the micro air assistant upper computer, select the corresponding port number, select the baud rate of 57600, and click to connect.
- Click on the radio icon in the function bar to open the VTX configuration interface. The upper computer will automatically recognize the VTX model and update the configuration interface.
- First read the settings, then modify the module parameters according to the requirements, and click the "Modify Settings" button to send the configuration command. The module will take effect after being powered on again.

Package Included:
- 1 x Pair of VTX Modules