- Our new PPM encoder allows you to connect your PWM-only RC equipment to PPM-only autopilot systems, like Pixhawk. Smaller than our previous PPM, our encoder will enable you to reduce all your channels to a single wire, excluding ground and power wires. As a result, you’ll get faster processing and reduced points of error.
The whole project is based around the ATMEL ATMEGA328p AVR processor and all timing is done within interrupts so accuracy and stability is optimized.
Specifications:
- Processor: ATmega 328 p microcontroller, firmware upgradeable via an AVRISP programmer
- Dimension: 30 x 20 x 5.5 mm (without cables)
- Weight: 8.7 g
Package Included:
- PPM encoder module
- PPM input cable to PWM receiver 10-position to servo (10 cm)
- PPM output cable to autopilot three-position to servo (17 cm)