RUSH TANK VTX 5.8GHz 48CH Video Transmitter PIT/25/200/500/800mW AV Transmitter For RC Drone

RUSH TANK VTX 5.8GHz 48CH Video Transmitter PIT/25/200/500/800mW AV Transmitter For RC Drone

DGP Competition Promotional Video: https://www.bilibili.com/video/av38424232
Flying Video: https://www.bilibili.com/video/av36882491
Image Transmission and Installation Tutorial: https://www.bilibili.com/video/av36442804

Description:
The RUSH Tank VTX is a high-quality 5.8GHz VTX with strong anti-interference ability and stable transmission. The TANK has four adjustable levels of transmitting power. They are PIT/25/200/500/800mW respectively.

This VTX has built-in SmartAudio protocol authorized by TBS. This can be set with RGB LEDs by conventional double buttons, which can then access SmartAudio ti set up and view the VTX information via the OSD menu. The Full metal casing means efficient heat dissipation as well as great protection from crashes and dings. Mounting hole distance of 30.5*30.5mm makes convenient stacking with your other electronics.

Package Included:
- 1 x RUSH TANK VTX

Note: Other items pictured are not included, for demonstration purposes only.

Wiring Instructions:
*The wiring of the RACING version is the same as the ULTIMATE version, and the connecting wires are common and interchangeable.
*For long-distance wiring or dense installation, it is recommended to twist the signal wire with the adjacent ground wire before wiring. The signal wire should be as far away as possible from interference sources such as ESCs to avoid unnecessary interference.
*Do not bend the antenna adapter cable excessively, as this will seriously affect the transmission efficiency of VTX and cause serious heating of VTX.
*The SmartAudio control line should be connected to any idle UART TX port of the flight controller. After TX is used, the RX of this port cannot be connected to other devices. After setting the ground station, you can use the OSD to set the image transmission. Please refer to the instruction manual for specific usage.
*The power input of ULTIMATE version is 7-25V wide voltage, and the power input of RACING version is 7-36V wide voltage, both of which can be used in the highest 6S power supply system.
*When the power distribution board or flight controller integrates 9V-12V BEC, please use the BEC power supply first to obtain the power supply with lower interference.
*When there is serious throttle interference on the screen, please first check whether the motor mounting screws pierce the motor windings and cause the rack to be charged. In addition, it is recommended to equip the four-in-one ESC with additional filter capacitors to increase the power filter effect.