STM32F051 Development Board (Better than STM32F0DISCOVERY and STM320518-EVAL)

STM32F051 Development Board (Better than STM32F0DISCOVERY and STM320518-EVAL)

Description:
- 2.0 V -3.6 V voltage operating range
- Cortex-M0 CPU (48 MHz max)
- Memory
- 64 K bytes Flash
- 8 Kbytes SRAM
- CRC check unit
- Clock Management
- Support 4-32 MHz external crystal oscillator
- Internal 40 kHz and 8 MHz RC oscillator
- With correction function 32K RTC, with a calendar function can stop or standby mode wake up the processor
- Reset and Power Management
- Power on / off reset
- Programmable voltage detector
- Low-power sleep, stop, and standby mode
- RTC battery powered backup registers
- 5-channel DMA controller
- 1 x 12-bit, 1.0 us ADC, 0 to 3.6V voltage detection range
- 2.4V to 3.6V analog supply independent
- Two low-power programmable input and output comparator
- All the way to 12-bit D / A
- Up to 55 channel I / O
- All can be mapped to the external interrupt
- Up to 36 channels I / O with 5V tolerant
- Up to 18 channel capacitive sensing channels that support touch buttons, linear and rotary touch sensors
- 96-bit unique ID
- SWD serial debugging
- Up to 11 timers
- 7-channel 16-bit advanced control timer, 6-channel PWM outputs with dead-time generation and emergency brake function
- A 32-bit and 16-bit timers, 4 IC / OC, available infrared remote control decoding
- A 16-bit timer, 4 IC / OC, an OCN, with dead-time generation and emergency brake function
- Two 16-bit timers, each with IC / OC, OCN function, with dead-time generation and emergency braking function for demodulation of infrared control gate
- A 16-bit timer with IC / OC function
- Independent system watchdog timer
- 24 downcounter
- A 16-bit basic timer is used to drive the DAC
- Communication Interface
- 2 I2C interface, supports fast mode Plus (1 Mbit / s), can accept 20mA current sink supports SMBus / PMBus and you can wake up in the stop mode
- 2 UARTs, SPI and support the main synchronous modem control, along with ISO7816 protocol support LIN and IrDA, with automatic baud rate detection and wake-up function
- 2 (18 Mbit / s), 4 16 programmable bit frame, and the way in which multiplexed I2S
 
Board features
- 2.54 pitch 20-pin JTAG interface
- RS232 interface
- RS485 interface
- SD memory card interface (SPI)
- 4 controllable LED
- Two user buttons
- An undirected navigation buttons
- IIC interface EEPROM
- IIC interface temperature sensor
- A light sensor
- A coin cell holder (due to air embargo unworthy button batteries)
- An SPI interface
- An IIC interface
- A UART interface
- An LCD screen interface
- All I / O with a 2.54mm pitch double pin interface leads
 
Checklist:
- STM32F051 development board x1
- Serial extension cable x1
- CD x1