ZYNQ7010 666MHz Processor Core Board 16MByte Onboard FLASH Support OPENCV for Xilinx FPGA Development

ZYNQ7010 666MHz Processor Core Board 16MByte Onboard FLASH Support OPENCV for Xilinx FPGA Development

Core Board Specification:
- Master chip model: XC7Z010-CLG400-1 (7010); XC7Z020-CLG400-2 (7020)
- Processor model: ZYNQ onboard hardcore processor, dual core Cortex-A9
- Processor main frequency: 666MHz (7010); 766MHz (7020)
- DDR3 (PS): 1024MB (bytes), 32 bit width, 1066 data rate
- DDR3 (PS) model: MT41K256M16TW-107:P, 2pcs
- Gold-finger expansion IO number: 92 (7010); 108 (7020)
- Logic unit (LC): 28K (7010); 85K (7020)
- Lookup table (LUT): 17600 (7010); 53200 (7020)
- DSP unit multiplier: 80 (7010); 220 (7020)
- Trigger: 35200 (7010); 106400 (7020)
- RAM: 2.1MBit (7010); 4.9MBit (7020)
- Speed level: -1 (7010); -2 (7020)
- Temperature range: industrial -40℃~85℃
- Note 1: ZYNQ configured DDR3 model as MT41K256M16RE-125, with higher actual model speed and compatible configuration.
- Note 2: 7010 does not equipped with BANK13 and is unavailable, so the 7020 core board has 16 more IO outputs than 7010.

Interface Functions:
- Power supply: all Type-C ports can be powered simultaneously. When running for Linux alone, please use UART port power supply to ensure USB stability.
- Development board clock: 33.33M(PS), 50M(PL)
- Ethernet: gigabit RTL8211E, one PS ETH0, one PL, dual network ports
- USB interface: USB 2.0, Type-C interface, supports Slave and Host. If you need a Host, please use C to A conversion interface.
- Debugger: onboard JTAG download debugger for Xilinx, supporting full development of ARM and FPGA.
- Serial port: CH340 serial port of PS, Type-C interface
- SD card: a PS TF card holder, SD0, support BOOT startup
- HDMI-compatible interface: one HDMI-compatible interface, output, maximum support 1080 at 60Hz (recommended 720P at 30Hz)
- LED and buttons: 1 PS button, 2 PL buttons, 4 PL LEDs, 1 PS LED and power supply
- Startup setting: a BOOT dip switch for startup settings
- Onboard FLASH: Winbond storage granules, W25Q128FVSG, 128Mbit (16Mbyte)
- System reset: a system reset button (POR)
- Indicator: one DONE signal indicator light, one USB power enable indicator light
- Expansion IO port: introduce 34 single-ended IO ports for BANK35, supporting only 3.3V, with a wiring length error of 200mil on the motherboard
- Note: debugging learning can use only one Type-C to connect JTAG debugging power supply.

Package Included:
- 1 x Core Board

Note:
- The base board is not included.
- Please contact our customer service to get development resources after receiving the product.